Custom made Peradon. Ebony and ash

[Harv]

60" long.
21oz

Had this custom built by Peradon about 5 years ago, very happy with the cue but I fancied going back to standard size. Anyway not sure how much this is worth. Open to offers.

Recently refurbed by Mike Wooldridge including new ferrule.

[Harv]

Also has ebony mini butt extension and mini telescopic extension

[burwat292596]

Hi Harv

Lovely cue from the pics.
Pls advise tip size, balance point, butt lenght (for shaft to fit in 3 piece case) also butt diameter and shaft diameter at 11 inches below the ferrule (looking for greater than 29.8 mm and 14.2 mm respectively).

Rgds & thanks
Ian

[Harv]

Hi Harv

Lovely cue from the pics.
Pls advise tip size, balance point, butt lenght (for shaft to fit in 3 piece case) also butt diameter and shaft diameter at 11 inches below the ferrule (looking for greater than 29.8 mm and 14.2 mm respectively).

Rgds & thanks
Ian

I like the cut of your jib. I shall gather this information post haste!

[burwat292596]

Thanx for that - taken almost 27 yrs to figure out my cue preferences!

[Harv]

can't find a tape measure or ruler, i'll get one tomorrow and let you know mate.

[burwat292596]

Hi Harv

Have you had time to check the specs yet?

Thanks
Ian

[Harv]

**** forgot about this, been too busy potting everything with my new cue! i'll get the specs today!

[Harv]

balance point - About an inch above the join
butt lenght (for shaft to fit in 3 piece case) 16"
also butt diameter 30mm
and shaft diameter at 11 inches below the ferrule - 15mm

cue fits in 3/4 length case no problem.