Been fooling around planing down an ash shaft and actually it is looking very good.
Not completely round yet which brings me to my question. If you have no lathe or fancy equipment how can you sand something like a shaft down to make it perfectly round?
I thought about drilling holes of different diameters in blocks of wood and then cutting those blocks in half. Should leave me with a perfectly round profile to use as a sanding block.
Any other ideas or comments?
Not completely round yet which brings me to my question. If you have no lathe or fancy equipment how can you sand something like a shaft down to make it perfectly round?
I thought about drilling holes of different diameters in blocks of wood and then cutting those blocks in half. Should leave me with a perfectly round profile to use as a sanding block.
Any other ideas or comments?
Comment