Brass joint at 3/4 length not flush with the wood finish

[fkhan]

Hello Folks,

Although, it does not affect cueing, could you please suggest how to make the 3/4 brass joint flush with the ebony butt wood?

Thanks,
fkhan

[Mark187187]

I'd recommend taking it to someone with a lathe

[fkhan]

Thanks. Can we use wire wool 0000 as well?

[anish147]

Thanks. Can we use wire wool 0000 as well?

I imagine wire wool would be far too gentle. Depends how much is sticking out, but perhaps someone with the correct tools is more likely to get the job done properly

[the lone wolf]

Andy Travis will do you a quick cheap but more importantly, excellent job!

[jrc750]

Andy Travis will do you a quick cheap but more importantly, excellent job!

He's not in UK though

[jrc750]

What is sticking out the most?
I assume the brass joint yeah?

[fkhan]

What is sticking out the most?
I assume the brass joint yeah?

Yes, the brass joint.

[fkhan]

He's not in UK though

from India.

[jrc750]

Yes, the brass joint.

How much is the cue worth?
If expensive I would get someone who knows what they are doing do it, if cheap have a go with wire wool 😎
Must be a cue maker or a machine shop in India who could look at it for you??

[fkhan]

How much is the cue worth?
If expensive I would get someone who knows what they are doing do it, if cheap have a go with wire wool ��
Must be a cue maker or a machine shop in India who could look at it for you??

cue is 150. I will try my luck with wire wool.

[DeanH]

wrap some masking tape over the shafts so you don't wear down by accident the softer wood before the brass - you don't want your cue to have an hour-glass figure do you :wink:

[fkhan]

wrap some masking tape over the shafts so you don't wear down by accident the softer wood before the brass - you don't want your cue to have an hour-glass figure do you :wink:

lol. I will use the tape. Thanks.