Announcement

Collapse
No announcement yet.

Orme & sons very nice Burr Oak Table with Ebony Trim

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Orme & sons very nice Burr Oak Table with Ebony Trim

    Last week I installed an Orme Table that we have had in stock for around 2 to 3 years , on one of the knee panles is a label for a repair by Orme in 1936 for the Rev Cannon Algernon Fearnley Cyril Youens , who is the late Vicar of Brodsworth village Church near Doncaster .
    I would say the table was made around 1910 - 20 .
    It has a very nice rare Burr oak Finnish to the side and ends of the frame , with very nice carved legs , also the trim is solid Ebony .
    It was a joy to errect, having a very good set of slates in near perfect condition .
    The polishing and wood work repairs we had done by a reputable finnisher of wood as we have no in house Polishing , and I must say the finnish is spot on , having a matt sheen that realy shows off the Grain of the burr oak .
    This table when it came into stock was in very poor state , some of the legs where missing half of the wood turning , the cushions where in very poor state also , having spent a good few years in a Police station canteen , having 6 foot burly Policemen lean all over the table .
    I used to service this table every 3 months in the Police station and often looked at the burr oak and thought , this table must have come from a very nice country house in its past , it was only on dismantle that I found the label to the rear of a knee panel , this gave us enough to research its history , and many thanks to Rev Youens Great Grand daughter who is an Editor for a well known top end country Magazine , for the information that connects the table to her Family and History of Brodsworth church Hall .

    Where it came from to Rev Youens we do not know , some think it came from Brodsworth Hall as the church is in the grounds of the Hall , but they have a table allready in the billiard room which is a little older than the Orme , so doubt that it came from there .
    more like another nearby country house was where it originaly came form .


    Last edited by Geoff Large; 7 September 2010, 07:52 AM. Reason: Photo added
    [/SIGPIC]http://www.gclbilliards.com

  • #2
    Very nice older table, much nicer looking than my BCE.

    I have a question off-topic Geoff. If you use that white marker to do the 'D' and spots, where do you source it from? I'm having trouble finding it here in Canada and may have to order from the UK on the internet.

    I even tried artist's supply store, but no go

    Terry
    Terry Davidson
    IBSF Master Coach & Examiner

    Comment


    • #3
      Peredon do a white pencil , but just one brush down and it is almost gone . you have to keep marking it out more often with a white pencil .

      what some fitters use is a white felt tip type pen , it should be water based if it is ink based then it will not erase with acetone on a stretch bed cloth , I use the white peredon Pencil , but prefer black , the only reason white is used is because it is better to see on TV , it is more common due to it lasting more that the marking is in black . French chalk would prob have been the first baulk line marker .

      If you have an offcutt of cloth then a trip to a good quality office stationers will source a white pen , try it on the off cutt cloth , also try and erase with acetone or nail varnish remover .

      Never use a felt tip pen of ink based type , especialy black and it could smear if acetone is used to erase it .

      I have just sourced this fabric marker which may do the trick .
      http://sewing-online.com/crafts/patc...en_Fine_White/
      but I am sure the peredon marker pencils are the safe way to mark out the baulk line without leaving a permanent line that cannot be erased with acetone .
      but search the Fabric and sewing shops for a fabric marker that may do the job , take a piece of scrap cloth with you if you have any to try the Fabric pens .


      Geoff
      Last edited by Geoff Large; 7 September 2010, 08:00 AM. Reason: more info
      [/SIGPIC]http://www.gclbilliards.com

      Comment


      • #4
        Thanks Geoff

        Terry
        Terry Davidson
        IBSF Master Coach & Examiner

        Comment


        • #5
          Wow Geoff,

          What a nice table, it must be a joy playing on one, very decent, thx for sharing.

          How much would one cost if I want to buy one similar?

          Comment


          • #6
            Thanks for the pics Geoff. It is a lovely table.
            :snooker:

            Comment


            • #7
              Originally Posted by bwls730 View Post
              Wow Geoff,

              What a nice table, it must be a joy playing on one, very decent, thx for sharing.

              How much would one cost if I want to buy one similar?
              this one was priced at £10.500 inc vat and delivery + instalation and also included a brass type shade with 6 lights and all cues and rests balls triangle etc .
              It has been discounted down from £15.000 , as the current market has declined , but I am aware of a couple of firms who would have priced this table up at £20.000 + vat and held out for that price , so the customer in my opinion got a very good deal .

              notice how dark the slate is , almost blue in colour , a sign of quality dense slate , from North Wales .
              Last edited by Geoff Large; 28 September 2010, 02:33 PM.
              [/SIGPIC]http://www.gclbilliards.com

              Comment


              • #8
                Thanks again

                Yes, a very beautiful table. When I win the lottery.........
                王可

                Comment


                • #9
                  Very nice table there mate .. Thanks for sharing the pictures

                  Comment

                  Working...
                  X