how to make a screw more than 3 metres and put enough spin in close distance?

[damienlch]

I bow Terry, but I dont think you can "tell" someone how to screw, or rather, you can tell them until you are blue in the face, and they still wont get it. Showing is the way to learn, and as we cant "show" over the internet, it is hard to teach anyone how to screw, and the stun run through is imposible to "tell" how its done.

It's all about touch.

Pratice is the only way to learn after watching or being shown.

My advise would be (if you only want to learn how to screw) is to forget about the pot as this isnt what you are after, keep the butt low, hit the ball low and dont hit it hard.

it wont be long until you start to screw it back 6 to 12 inches, then you can keep at it until you git it right.

I agree with what you have said. Imparting/sharing knowledge and technique is one thing. Absorbing them, understanding them and putting them into practice, now that takes much dedication.

This reminds me of a passage from a book I read recently; "The Way of the Bow" by Paulo Coelho...

"...Teaching it isn't hard. I could do that in less than an hour... The difficult thing is to practise it every day, until you achieve the necessary precision..."

[cantpotforshíte]

My advise would be (if you only want to learn how to screw) is to forget about the pot as this isnt what you are after

If there is a secret to screwing back I reckon this is it. If you're lined up correctly, the pot should take care of itself, and it's so much easier to screw back if you aren't trying to pot anything.